Whether you are getting a new roof installed or replacing your existing one, it is important to have accurate measurements of the roof so that you can order the proper amount of materials. While using Google Earth is a good starting point, it is best to use a tape measure and take actual field measurements. This will ensure that you aren’t overestimating or underestimating the square footage of your roof. This is especially important when bidding a job or ordering materials.
Before the roofing work begins, the crew will prep the area around your house for safety and convenience. This might include putting down tarps where necessary, positioning garbage cans so that any debris that falls off the roof goes into them rather than your yard or driveway, and moving vehicles and other objects away from the exterior of your home. This will also help keep your home clean and safe, and it can make the whole process more efficient.
Once the prep work is done, it’s time to begin the actual roofing process. Depending on your roof’s material, the contractor may start by laying an ice and water barrier or underlayment (usually made of felt). Then, they’ll lay the first course of shingles. If you have asphalt shingles, the crew will install them from the bottom edge of your roof up, making sure that each new shingle overlaps the previous shingle. If you have clay tiles, the crew will start at the eaves and work their way up.
Next, the crew will inspect and replace any flashing that’s rusted or damaged. This includes the drip edge as well as flashing around chimneys, vents, and valleys. It’s very important that these areas be properly flashed to prevent leaks and protect the interior of your home from moisture.
Finally, the crew will re-install any drip edges that were removed during preparation. This will help to protect your gutters and ensure that the shingles or other roofing material don’t drip onto them as you work.
After all of this, the crew will install the actual roofing materials. Whether you have shingles, clay tile, or some other type of material, the crew will install it according to the manufacturer’s guidelines. For example, the shingles will be placed with an appropriate amount of overlap and sealant will be applied where needed.
If you’re in the market for a new roof, be sure to hire a reputable and experienced roofing contractor. Check their credentials by contacting the manufacturer of your chosen roofing materials and asking them for a list of certified contractors in your area. It’s also a good idea to get quotes from several different contractors before you decide who to hire. This will help you ensure that you’re getting the best value for your money and the highest-quality installation possible.
source https://albertbakerroofingptyltd.wordpress.com/2024/08/10/how-roof-installation-works/
No comments:
Post a Comment